terewtm.blogg.se - Gambar ebiet g ade

Gambar ebiet g ade how to#
Gambar ebiet g ade drivers#
Gambar ebiet g ade code#
Gambar ebiet g ade series#

Now, proceed as before, but follow a different sequence of steps:Īfter final data is read, the file required to calculate your unlocking code is located in the Nokia BEST: " Local_cal" Nokia C-3) is expected to fully boot up the phone by the user (red checkmark) N500) the data reading should be automated to the end, or (eg. Only the description of the main window.Īfter USB cable is connected, the program continues reading data and depending on your phone model (eg. If you succeed to connect the cable program will starts reading the data needed to unlock, wait a while, in according to message "wait".Īfter while, you will be asked to repeat the sequence from step 4 (disconnect the cable, remove the battery - insert the battery, connect the cable) - a red check mark.Īs you can notice there is no longer a separate window that shows actions required by the program as described in Section 4. If you unlucky to attached phone to the USB cable within those 20 seconds (counter is in the lower left corner of the window) - the whole procedure will need to be repeated. For about 20 seconds the program is waiting for a USB cable to be plug in to already turned off phone. Now with smooth move plug in usb cable to the usb slot (be percaution because cable can give not enough strong pulse if it slips, and the program would not read the data - and you will need to repeated the procedure from the begining) Click OK in program window - confirming that the previous procedures have been done (selection No. Turn off your Nokia - switching off with Power button is not always successful so the best way is to pull out the battery from phone and insert the battery back into the phone. Now unplug NOKIA C2-01 from computer - disconect the USB cable and do not connect it again

Gambar ebiet g ade series#

You will see in Log window messages asking to perform a series of three operations:.

1) and then click on Create file for LBF (marked in red with No.

Gambar ebiet g ade drivers#

If the drivers were installed correctly you will get the information that the program merged with the NOKIA C2-01 (marked in red message).

Or as an alternative (based on NokiaBest) if you had any issues with reading data in Nokia Best program, use in that case : From phone menu, choose Nokia Suite connection mode (if phone wasn't in this mode already ) - wait for phone to be found by Nokia Suite.Plug the usb cable to the phone and wait for drivers instalation (which are in Nokia Suite).First download Nokia Suite and install it.Let's start ! Setup proper cable connection between your NOKIA C2-01 and the computer. What you have to do to read the part of data which is necessary to remote calculation of the unlocking code for Nokia S元 protected phones? If someone enter wrong codes you can use Nokia BB5 Utility.BruteForce is the way of calculate unlocking code from part of data read from Nokia phones which allowed you to unlock your NOKIA C2-01.

In Nokia phones you may enter the code via keyboard only 3 times. This may be necesary if your phone has a blocked code counter. It is also possible to enter the code via USB cable.

Note: replace CODE with the unlock code we send you.

Press OK to be able to enter the unlock code.

It should state that the SIM is restricted,

Turn on NOKIA 2730 classic with a non-accepted SIM card inserted.

The letter + appear after press 2 times quickly the button star (*).

The letter W appear after press 4 times quickly the button star (*).

The letter P appear after press 3 times quickly the button star (*).

The phone show "SIM Restriction Off" and was unlocked.

Compose #PW+CODE+1# (if locked from Fido/Roger Canada, please compose#PW+CODE+7#),.

Switch ON your NOKIA 2730 classic without SIM Card,.

Gambar ebiet g ade how to#

How to enter code for NOKIA 2730 classic: